Hooker Competition Headers
![]() Hooker Headers 2462-1 Competition Headers US $445.98
|
![]() Hooker Headers 3902-1 Competition Headers US $461.98
|
![]() Hooker Headers 6920 Competition Headers US $231.98
|
![]() Hooker Headers 7901 Competition Headers US $204.98
|
![]() Hooker Headers 2456 Competition Headers US $192.98
|
![]() Hooker Headers 3901-1 Competition Headers US $455.98
|
![]() Hooker Headers 2456-3 Darkside Competition Header US $483.98
|
![]() Hooker Headers 16665 Competition Exhaust System US $225.97
|
![]() Hooker Headers 2455 Competition Headers US $188.97
|
![]() Hooker Headers 2457 Competition Headers US $198.98
|
![]() Hooker Headers 2460 Competition Headers US $168.98
|
![]() Hooker Headers 21005 Competition Turbo Muffler US $44.98
|
![]() Hooker Headers 16523 Competition Exhaust System US $194.97
|
![]() Hooker Headers 16661 Competition Exhaust System US $215.98
|
![]() Hooker Headers 2451 Competition Headers US $168.98
|
![]() Hooker Headers 2453 Competition Headers US $178.98
|
| Powered by phpBay Pro |

How much horse power would I have with a chevy 350 with...?
600 cfm edelbrock performance series carb
gilmer 3" wide belt
high volume water pump
high volume oil pump
487 cast # 76 cc heads
hooker competition headers
bored .060 over
comp cam somewhere around .480-.500 lift and 270 duration for intake and exhaust
Tuned to the gills, you'll make in the neighborhood of 1HP per inch.
It's going to make peak torque around 4000 and peak power in the low 5000 range. Will run to 6000 but won't make any power at that point.
I would definitely run a one inch thick 4 hole carb spacer as well.
You'll need to change metering rods as that carb likely has 70/47's in it which for the power step being 47 is WAY too fat at WOT unless you have quite a heavy shot of Alcohol in the gas. I would step that up from 47 to either a 68/52, a 70/57, or a 75/57 metering rod. From there, let plug readings on the spark plug base ring(not the porcelain) tell you if it wants more or less fuel.
I would also run a fel pro 1094 head gasket.
Outside of that, not the best head for a factory casting you could use and far from the best cam.
Items Recently Purchased From This Site:
| Powered by phpBay Pro |

















































































